+ =======================================
+ ---
+ Version 1
+   Created from G-Code Arcs (mm) (*.tap)
+ =======================================


POST_NAME = "Blue Elephant ATC Arcs (mm) (*.tap)"

FILE_EXTENSION = "tap"


UNITS = "MM"

+------------------------------------------------
+    Line terminating characters
+------------------------------------------------

LINE_ENDING = "[13][10]"

+------------------------------------------------
+    Block numbering
+------------------------------------------------

LINE_NUMBER_START     = 0
LINE_NUMBER_INCREMENT = 10
LINE_NUMBER_MAXIMUM = 999999

+================================================
+
+    Formating for variables
+
+================================================

VAR LINE_NUMBER = [N|A|N|1.0]
VAR SPINDLE_SPEED = [S|A|S|1.0]
VAR FEED_RATE = [F|C|F|1.1]
VAR X_POSITION = [X|C|X|1.3]
VAR Y_POSITION = [Y|C|Y|1.3]
VAR Z_POSITION = [Z|C|Z|1.3]
VAR X_HOME_POSITION = [XH|A|X|1.3]
VAR Y_HOME_POSITION = [YH|A|Y|1.3]
VAR Z_HOME_POSITION = [ZH|A|Z|1.3]
VAR ARC_CENTRE_I_INC_POSITION = [I|A|I|1.3]
VAR ARC_CENTRE_J_INC_POSITION = [J|A|J|1.3]

+================================================
+
+    Block definitions for toolpath output
+
+================================================

begin REVISION_COMMENT

"(VECTRIC POST REV. WILMER VALERO)"
"(tel. +57 310 5719964)"

+---------------------------------------------------
+  Commands output at the start of the file
+---------------------------------------------------

begin HEADER

"G17"
"M06T[T]"
"G43H[T]"
"[S]M03"
"G0[ZH]"
"G0[XH][YH]"

+---------------------------------------------------
+  Commands output at toolchange
+---------------------------------------------------

begin TOOLCHANGE

"M06T[T]"
"G43H[T]"
"[S]M03"

+---------------------------------------------------
+  Commands output for rapid moves
+---------------------------------------------------

begin RAPID_MOVE

"G0[X][Y][Z]"


+---------------------------------------------------
+  Commands output for the first feed rate move
+---------------------------------------------------

begin FIRST_FEED_MOVE

"G1[X][Y][Z][F]"


+---------------------------------------------------
+  Commands output for feed rate moves
+---------------------------------------------------

begin FEED_MOVE

"[X][Y][Z]"

+---------------------------------------------------
+  Commands output for the first clockwise arc move
+---------------------------------------------------

begin FIRST_CW_ARC_MOVE

"G2[X][Y][I][J][F]"


+---------------------------------------------------
+  Commands output for clockwise arc  move
+---------------------------------------------------

begin CW_ARC_MOVE

"G2[X][Y][I][J]"


+---------------------------------------------------
+  Commands output for the first counterclockwise arc move
+---------------------------------------------------

begin FIRST_CCW_ARC_MOVE

"G3[X][Y][I][J][F]"


+---------------------------------------------------
+  Commands output for counterclockwise arc  move
+---------------------------------------------------

begin CCW_ARC_MOVE

"G3[X][Y][I][J]"

+---------------------------------------------------
+  Commands output at the end of the file
+---------------------------------------------------

begin FOOTER

"G0[ZH]"
+ "G0[XH][YH]"
"M30"